Ultimate Complete Optimizing Spring Kit for SFS (Fast Safety) equipped Hi-Powers

Description

Spring Kit especially developed for SFS (Fast Safety) equipped Hi-Powers

Kit includes:

3 BHSS RECOIL SPRINGS

17 lb Standard Recoil Spring (for most standard pressure ammo)

18.5 lb Recoil Spring (for high powered ammo)

15 lb Recoil spring (for lighter ammo and low power factor reloads that won’t cycle with standard 17 lb. recoil spring)

All Recoil Springs are made with BHSpringSolutions proprietary Closing Coil ends, designed to Optimize Spring Performance throughout the recoil cycle – specifically,the BHSS Closing Coil provides maximum resistance at the beginning of recoil, prior to barrel unlocking from slide – contributing to excellent Hi Power accuracy.

2 TRIGGER RESET SPRINGS

 2-Coil TACTICAL Trigger Reset Spring is the heavier of the BHSS Trigger Return Springs and provides a more authoritative forward trigger reset.  Excellent for tactical and carry uses.

 3-Coil TARGET Trigger Reset Spring lightens trigger pull while retaining  sufficient reset for the preferences of some shooters for carry use.

 

EXTRACTOR SPRING

 A Tiny SPRING that is hand made from start to finish.  Also known as, pound for pound, the hardest working spring in the Hi Power design.  When this spring becomes too weak, it causes malfunctions.  The BHSpringSolutions Extractor Spring equals or exceeds the most robust Extractor Springs ever produced for the Hi Power design, and hand filed on each end for optimal flat surface contact. We recommend Extractor Spring Replacement every 5 Years or 5,000 Rounds.  

 

FIRING PIN SPRING

 Retains the Firing Pin in it’s rearward most position.  This kit includes heavy (typical for Hi-Powers without FPS)

 

MAIN (HAMMER) SPRING SFS Version

Another hard working spring that is not equal in all Hi Powers and Clones.   Using the correct main spring for your model Hi Power is critical to proper function.   Made with all the benefits of BHSpringSolutions build quality and Closing Coil design.

 

 

SAFETY LEVER SPRING SFS Version

 

   

MAGAZINE LATCH SPRING

 This spring is responsible for positive magazine lock-up, and magazine retention in the grip frame.  Different Hi Power manufacturers have made stronger and weaker versions of this spring.  The BHSpringSolutions Magazine Latch Spring is a stronger version that helps prevent inadvertent magazine release when holstering and handling the firearm, provides excellent and positive magazine lock-up, and smooth/decisive magazine release operation.

 

MAGAZINE DISCONNECT SPRING (OPTIMIZED)

 Located in the Trigger Assembly, the Magazine DisconnectSpring is responsible for disabling the trigger when the magazine is removed, and correctly positioning the trigger bar when the magazine is installed.  Arcus and Kareen  lightened this spring while retaining proper trigger bar function/positioning, resulting in a smoother/lighter/better trigger pull.  BHSpringSolutions Magazine Disconnect Spring is a lighter/optimized version.

 

SEAR LEVER SPRING
Located in the Hi Power slide of models with a firing pin block safety. When this spring is not made to specs, the result can adversely affect trigger pull.

 

SFS HAMMER RETURN SPRING

 

BHSpringSolutions tests it’s recoil springs by mechanically cycling, 10,000 times, a representative sample of each production run.  Typical result after 10,000 cycles is a loss of only 1mm of relaxed recoil spring length, and only ½ lb of resistance – remaining “fit for service” (within acceptable specs for use in the Hi Power design).

All BHSpringSolutions Coil Springs are made with BHSS Optimized “Closing Coil” on both ends, and certain springs are further hand-filed on each end for maximum surface contact and performance.