HiPower Main Springs - 4 pack
5107 Item Items
Warning: Last items in stock!
BHSS Optimized Main Springs for Browning Hi Power and Clones
Contains the Following BHSpringSolutions Hi Power Main (Hammer) Springs in 32 lb., 30 lb., 26 lb., 24 lb.
32 lb. BHSS Main Spring – OEM in FN/Browning Hi Powers and many identical Hi Power Clones.
30 lb. BHSS Main Spring - OEM in Kareen Mark II/III and Arcus 94. Preferred by many Hi Power owners in all Hi Powers.
26 lb. BHSS Main Spring - OEM in Arcus 98DA/98DAC, and often preferred by gunsmiths for all Hi Power models for betterment of trigger pull. Normally does not necessitate a stronger Recoil Spring when all springs are “healthy”.
24 lb. – BHSS Main Spring - Makes slide significantly easier to rack against the resistance of the hammer. May necessitate a stronger recoil spring for rearward slide velocity control.
BHSpringSolutions LLC Recoil Springs are tested by mechanically cycling, 10,000 times, a representative sample of each production run. Typical result after 10,000 cycles is a loss of only 1mm of relaxed recoil spring length (retaining 99% of original relaxed length), and only ½ lb of resistance (retaining 97% of original resistance) – remaining “fit for service” (within acceptable specs for use in the Hi Power design).
All BHSpringSolutions Coil Springs are made with BHSS Optimized “Closing Coil” on both ends, and filed on each end for maximum surface contact and performance. BHSpringSolutions LLC exacting dimensional length standards assure optimal spring resistance and performance at all points of the spring’s compression and decompression.
BHSpringSolutions LLC recommends a Best Practices approach of complete Spring Replacement, every 5 years or 5,000 Rounds, with BHSpringSolutions LLC Optimizing Springs. In shorter barrel handguns classified as “Commander”, “Compact”, “Detective”, “Subcompact”, “Officers”, etc., a more frequent recoil spring change regimen is recommended.
You accept that it is solely your responsibility to assure that any firearm you may own, possess, handle or work on, is completely unloaded and handled in a safe and responsible manner at all times and that you hold harmless BHSpringSolutions LLC, its employees and officers, from any and all liability resulting from use of firearms.
You acknowledge that it is your responsibility to assure that your firearm(s) are functioning in a safe and reliable manner and that if not, whether you have installed a BHSpringSolutions LLC product or not, you will take any and all measures, including repairs by a qualified Gunsmith, required to correct such issues before loading and using your firearms.
No customer comments for the moment.